Posted by member 2629 on 2003-01-31 05:56:46 link

When I ran simplicity I found that certain modes would not load or partially load when switching after a while of uptime... usually the VWM and then the geekamp... the lsxcmd was then the only one that worked... I think this might happen from a logic error in the code... an instance (or even maybe several) that you eventually run across in run time. I reccommend a close look at the step and the other .rcs. I think, from a fresh quick look at it that there are quite a few modules that don't need to be loaded or used... they were put there just in case, but they might conflict with the modules that are in the mode (I've run into problems with label18 and rainmeter running together, just an idea though)... otherwise, just change your theme... simplicity is great, but LiteStep is so customizable that you should at least use someone else's theme thats set more to your liking... hope this helps your stepping... enjoy!