Tile Windows Thread last updated on 2004-05-07 19:20:27

Posted by member 153367 on 2004-05-06 22:58:06

Is there a way to invoke a command that will tile the windows, horizontally or vertically? I would appreciate the help.

Posted by member 1 on 2004-05-07 00:01:44 link

5 seconds after reading this question I found the answer so I refuse to post it here until you do some research.

Posted by member 7991 on 2004-05-07 12:11:10 link

DevilBoi: 5 minutes after reading your response, I still haven't found the answer. Why waste your time posting such a reply if you could have, in as many words, stated the answer to the question? Put the ego away, its not flattering. If you are too much of an elitist to help someone out, then just don't respond. Oh, and could you please respond to this message with "RTFM", because that would be great.

Posted by member 1 on 2004-05-07 17:18:06 link

RTFM!

Why waste your time asking a question that is answered in the freaking manual!? Its not that I am an elitist or have this huge ego...it is that I have no patients for people who can't read the manual and think LS is for them and that the community will carry them through any issue. Hell you couldn't even run !About to find out what bang commands you already had defined...now that is uber lazy!

Posted by member 1949 on 2004-05-07 17:45:40 link

The answers is: Yes
!about to display available command bangs...
!TilewindowsV
!TilewindowsH
!CascadeWindows